Pd(II)催化烷基 diazirine 脱氮
Palladium(II)-Catalyzed Denitrogenation of Alkyl Diazirines
[PdCl2(NCPh)2] 在 CDCl3 中于 25 °C、16 h 催化单烷基 diazirine 脱氮,生成相应烯烃的产率最高 70%。(4-氟苯基)diazirine 在 20 mol % 该催化剂与过量苯乙烯存在下生成 1-(4-氟苯基)-2-苯基环丙烷,产率 48%(cis/trans = 6.7:1)。
- 背景
- 单烷基二氮丙啶(diazirine)的脱氮通常需要在较高温度下进行,能否在温和条件下由钯催化实现,此前并不清楚。
- 做法
- 以 [PdCl2(NCPh)2] 为催化剂,在 CDCl3、25 °C 下反应 16 h,考察单烷基二氮丙啶的脱氮;并用动力学实验、钯配位络合物的原位分析和 DFT 计算追踪反应路径。另将 (4-氟苯基)二氮丙啶与催化量 [PdCl2(NCPh)2](20 mol %)和过量苯乙烯反应。
- 结论
- 脱氮生成相应烯烃,产率最高 70%;与苯乙烯的反应得到 1-(4-氟苯基)-2-苯基环丙烷,产率 48%,cis/trans = 6.7:1。计算支持如下路径:四配位 trans-钯 σ-二氮丙啶络合物经 C─N 氧化加成形成五配位 Pd(IV) 二氮杂金属杂环丁烷,随后 Pd─C 断裂、异构化为 C-键合重氮络合物并挤出 N2 生成 trans-钯烷叉,最后经 1,2-H 迁移得到 π-苯乙烯络合物。
- 意义
- 该工作给出 Pd(II) 催化二氮丙啶脱氮的实验证据与逐步能量剖面,关键步骤能垒分别为 22.4、8.8、4.2 和 5.0 kcal/mol;作者对异构化提出经分子间配体交换的推测,机理细节仍待进一步验证。
原文摘要
出版方登记 · Crossref[PdCl2(NCPh)2] catalyzes the denitrogenation of mono(alkyl) diazirines in CDCl3 at 25 °C for 16 h to form the corresponding alkene in up to 70% yield. Reaction of (4-fluorophenyl)diazirine with a catalytic amount of [PdCl2(NCPh)2] (20 mol %) and excess styrene forms 1-(4-fluorophenyl)-2-phenylcyclopropane in 48% yield (cis/trans = 6.7:1). Kinetic experiments, in situ analysis of palladium coordination complexes, and DFT calculations support a mechanism for Pd(II)-catalyzed denitrogenation of benzyl diazirine involving C─N oxidative addition (ΔG‡ = 22.4 kcal/mol) of a four-coordinate trans-palladium σ-diazirine complex to form a five-coordinate Pd(IV) diazometallacyclobutane complex. Subsequent Pd─C bond cleavage (ΔG‡ = 8.8 kcal/mol) to form an N-bound diazo complex followed by isomerization to the corresponding C-bound diazo complex, presumably via intermolecular ligand exchange, and facile (ΔG‡ = 4.2 kcal/mol) extrusion of dinitrogen forms a trans-palladium alkylidene complex. Concerted, 1,2-H migration (ΔG‡ = 5.0 kcal/mol) forms the corresponding four-coordinate palladium π-styrene complex.
页面未能读取全文,以上为出版方登记的摘要;方法与图表见原文
本页是 AI 精读,不转载论文原文;完整论文(含方法、图表与参考文献)见原文
来源:ACS Catalysis · doi.org